Sony Metz SCA 3302 M7 - Manual (Page 45)

The camera’s shutter speed must not be faster
than 1/60th sec for the Cordless Metz Remote
Mode! The Dimage ... digital cameras only
support the Metz Automatic Remote Mode.
4.18 Multi-zone flash exposure metering
(preflash metering or TTL preflash)
When the camera’s shutter release is pressed for
picture shooting a pre-flash is fired to measure the
subject’s reflection. With the aid of its exposure
system and its 14-segment honeycomb pattern
multi-zone metering (Dynax 7 / Dynax 9), the
camera’s electronics captures the light reflected by
the subject. It then determines the optimal
weighting for the 4 segments of flash exposure
metering on the basis of the measured light distri-
bution and the information given by the AF system.
The subsequent main flash and the consequent
exposure are performed according to the results of
this pre-flash metering. For the setting procedure
of multi-zone flash metering on the camera and
other details please refer to the camera manual.
Because of the preflash, it is not possible for
system-induced reasons to use an external
flash meter for multi-zone flash metering.
4.18.1 Dynax 7, 9
For system-induced reasons only the meca-
blitz 54 MZ-... can be used for multi-zone flash
exposure metering with the above cameras!
The mecablitz 54 MZ-... must be set to TTL-HSS
mode for multi-zone flash exposure metering (see
Section 4.13.1). Multi-zone flash exposure meter-
☞
☞
☞
45
ķ
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 45