Woodstock SHOP FOX W1715 - Manual (Page 26)

-24-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
FG
<
I
8
K@FEJ
9cX[\Jg\\[
The bandsaw is capable of operating at 78, 108, or 180
FPM. The speed can easily be adjusted by changing the
V-belt placement.
=`^li\*+ shows an illustration of each
pulley to belt combination, and the following list provides
the blade speeds in feet per minute.
9\ckGfj`k`fe 9cX[\Jg\\[
8 ....................................................... 78 FPM
9 ...................................................... 108 FPM
: ...................................................... 180 FPM
KfZ_Xe^\k_\YcX[\jg\\[j#[fk_\j\jk\gj1
(% DISCONNECT BANDSAW FROM POWER!
)% Unthread the V-belt tension hex bolt to allow the
motor to pivot ( =`^li\*,).
*% Raise the motor to relieve the belt tension and
position the belt in the desired pulley alignment.
+% Release the motor and let the motor weight tension
the belt.
,% Position the V-belt tension hex bolt back against the
frame of the bandsaw.
DfkfiGlcc\p >\XiGlcc\p
:
9
8
=`^li\*+% Pulley configurations.
=`^li\*,% V-belt tension hex bolt.
V-belt Tension
Hex Bolt