Woodstock SHOP FOX W1715 User Manual
Page 16
-14-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
J<
K
L
G
-% On the other leg, insert the handle into the pre-
drilled holes and secure it with the cotter pins (see
=`^li\(').
=`^li\('% Handle installed with cotter
pins.
Cotter
Pin
.% With the help of an assistant, lift the bandsaw onto
a pair of closely spaced sawhorses or other suitable
support (see
=`^li\(().
/% Attach the legs to the bandsaw with the M8-1.25 x
25 hex bolts, 8mm flat washers, and M8-1.25 hex
nuts. Tighten them with a 14mm wrench or socket
just enough to secure the parts. Final tightening will
take place when the stand is fully assembled.
0% Remove the machine from the sawhorses, then
install the tool tray in the middle of the stand with
the M6-1 x 12 Phillips head screws, 6mm flat washers
and M6-1 hex nuts, as shown in
=`^li\().
('% Check to see if the bandsaw is relatively level, then
final tighten all the nuts.
K_\ YXe[jXn `j X _\Xmp
dXZ_`e\ (++ cYj% Lj\
Xjj`jkXeZ\ Xe[ jX]\ c`]k`e^&
dfm`e^d\k_f[jn_\ec`]k`e^
k_`jdXZ_`e\%
=`^li\((% Attaching leg assemblies.
=`^li\()% Installing tool tray.