Sharp R-930AK - Manual (Page 5)

3
Unpacking and Examining Your Oven
Remove:
1. all packing materials from inside the oven cavity.
Read enclosures and SAVE the Operation
Manual. DO NOT REMOVE AND THROW OUT
THE WAVE GUIDE COVER.
2. the feature sticker from the outside of the door,
if there is one.
Check the oven for any damage, such as misaligned
or bent door, damaged door seals and sealing
surfaces, broken or loose door hinges and latches
and dents inside the cavity or on the door. If there is
any damage, do not operate the oven and contact
your dealer or SHARP AUTHORIZED SERVICER.
Choosing a Location for Your Oven
You will use your oven frequently so plan its location
for ease of use. The oven must be placed on a
countertop which is a minimum of 36 inches from the
floor. Allow at least 2 inches on the sides, top and at
the rear of the oven for air circulation. Be sure to
position oven so that the rear cannot be touched
inadvertently.
Your convection microwave oven can be built into a
cabinet or wall by itself or above any Electric wall
oven or warming drawer using Sharp’s Built-in Kit
listed below. It cannot be built in above any gas wall
oven.
Oven Cavity
Door Seals and
Sealing Surfaces
Hinges
Latches
MIN.
1 / " 2
1
MICROWAVE CUTOUT
ELECTRIC WALL
OVEN/WARMING
DRAWER CUTOUT
Sketch-1
MIN.
36"
INSTALLATION INSTRUCTIONS
Sharp Convection
Microwave Oven Model
R-930AK
R-930AW
R-930CS
Applicable
Built-in kits
RK-66A
RK-66WB
RK-93S27
RK-93S30
Note for R-930CS:
Select the Built-in kit RK-93S27 or RK-93S30 depending on the desired finished width. The RK-93S27 is for
a 27 inch and the RK-93S30 is for a 30 inch finished width.
See Sketch 1 for proper location when building in above an electric wall oven or a warming drawer. Carefully
follow both the electric wall oven/warming drawer installation instructions and Sharp’s Built-in Kit instructions.
Be sure that the clearance of the floor between the electric wall oven/warming drawer and the microwave oven
is minimum of 1
1 /
2
inches.
Ordering the Built-in Kits.
If your dealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center.
Have your credit card number available and call toll-free: 1-800-237-4277 for ordering the kit to be sent to your
address.
The kit includes ducts and finish trim strips and easy-to-follow instructions for installation as well as the location
of the power supply.
P.01-P.11 06.9.28, 2:59 PM 3