Smeg PLA8743X - Manual (Page 85)

22 Rev 0.0
INSTALLATION INSTRUCTIONS EN
Connecting to the air gap (no waste disposal unit)
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE
DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR
ON WHICH THE DISHWASHER WILL BE INSTALLED.
Connect the dishwasher drain hose (ref. A fi g. 5-13) to the air gap (ref. B fi g. 1.
5-13) using the wide spring clamp (ref. C fi g. 5-13); if necessary, cut the end
of the dishwasher drain hose (ref. D fi g. 5-13) (do not cut the corrugated
section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”)
screw clamp*.
To connect the air gap (ref. B fi g. 5-13) to the “T” union (ref. E fi g. 5-13) of the
2.
drain line, use a rubber union* (ref. F fi g. 5-13) with spring or screw clamps*
(ref. G fi g. 5-13).
* Available from any plumbing stockist
Fig. 5-13
B
C
A
F
G
G
D
E