Smeg PLA8743X - Manual (Page 11)

10
Rev 0.0
USER INSTRUCTIONS EN
Only run the soak program with half loads.
To run programs 6, 7, 8, 9 (see tab. 2-03b), select the required standard pro-
gram (see programs 2, 3, 4, 5 in tab. 2-03a) and then press the “soak” button
(program 1 in tab. 2-03a).
The half-load option (ref. 3 fi g. 2-03) is available for all programs, except the
soak program.
After using the above tables to choose the most suitable washing cycle, pro-
gram the appliance.
Before starting a washing program, make sure that:
The water supply tap is open.
There is regenerating salt in the water softener tank (to add
salt, see the instructions in the general manual).
The correct amount of detergent has been added to the dis-
penser (to add detergent, see the instructions in the general
manual).
The spray arms are able to rotate freely and without obstruc-
tion.
The racks have been correctly loaded (see the instructions in
the general manual).
The dishwasher door is securely closed.
2.2.1 Switching on
Press the on/off button (ref. 1 fi g. 2-03) to start the dishwasher. The relative
indicator light (ref. 6 fi g. 2-03) shines. Approximately 3 seconds later, the dis-
play (ref. 8 fi g. 2-03) will light up, showing information that will depend upon
the state of the dishwasher.
•
•
•
•
•
•