beautypg.com

Operating instructions – Shark EP710 User Manual

Page 3

background image

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Fig. 1

Handle Assembly

1. Remove the screw located just below

the top edge of the back of the

vacuum. (fig. 1)

Cord Assembly

1. Make sure that the quick release

cord holder is in the upright

position.

2. Remove the wire tie from the

power cord.

3. Wrap the cord into place by

wrapping it in a clockwise direction

around the quick release cord

holder and the lower cord holder

as shown. (fig. 3)

2. Position the handle as shown in fig. 2.

Fig. 2

3. While holding the power cord out of the

way, slide the handle into the opening at

the top of the vacuum.

4. Insert the screw so that it passes

through the handle into the vacuum.

5. Begin to tighten the screw with your

fingers. It may be necessary to adjust

the handle slightly. Using a screwdriver,

tighten the screw.

Caution:

Do not over tighten. Over

tightening could strip

the screw holes. Do not

operate the vacuum

without the screw in place.

Fig. 3

4. Turn the quick release cord holder

to the left or to the right to unwrap

the power cord. (Fig. 4)

Fig. 4

Assembling Your Vacuum Cleaner

Attachment Storage

After the handle has been assembled to

the body of the vacuum and the power

cord has been wrapped around the

cord holders, the attachments can be

assembled.

1.

Insert the end of the hose into one

of the extension tubes and place

this extension tube into the slot of

the inlet hose.

2.

Loop the loose hose over the hose

hook.

3.

Place the other extension tube into

the extension tube holder.

4.

Slide the crevice tool inside the

extension tube when not in use.

5.

Place the dusting brush into the

dusting brush holder.

Carpet Height Adjustment

To select a pile height setting:

1. Turn vacuum cleaner "Off".

2. Select a pile height setting by tilting

the vacuum cleaner back until the

front wheels are lifted slightly off the

floor.

3. Slide the adjustment lever to the

desired setting. (Fig. 6)

Suggested Pile Height Setting:

You may need to raise the height of the

vacuum to make some jobs easier,

such as scatter rugs and longer pile

carpets. Suggested settings are:

HIGH:

shag carpet, long pile, plush

scatter rugs

MED:

medium to long pile

LOW:

short to medium pile, bare

floors

EX LOW: very low pile, bare floors
Place unit in "HIGH" setting when using

attachments to prevent possible floor

damage.
Attention: Special care is required

when vacuuming certain types of carpet

or floor covering. Always check the

carpet or floor covering manufacturer's

recommended cleaning instructions

before vacuuming.

Note:

Always remove the power plug

from the wall outlet before assembling or

removing accessories.

How to Start

The upright vacuum can be used on

multiple types of carpeting, bare floors

or upholstery with attachments. When

using the attachment tools such as the

crevice tool and the dusting brush,

place the handle of the vacuum in the

upright position. (Fig. 5)

1.

Turn the quick release cord holder

to either side 180° to release the

power cord.

2.

Plug the power cord into the

electrical outlet.

3.

Step on the handle release pedal

to release the handle.

4.

Step on the On/Off button to turn

the vacuum "On".

Fig. 5

Warning:

Do not plug in if the power

On/Off button is in the

"On" position.

Fig. 6

5

4