Sirius Satellite Radio SSDK1 - Manual (Page 27)

Home Signal Distribution Kit Installation Guide
4. adjusting and aiming the antenna
The pod portion of the antenna (where the SIRIUS logo is printed) needs to be
adjusted and aimed so that it is level and horizontal to the sky. There are two
possible adjustments that may be made on the antenna to accomplish this: tilting
the antenna pod itself (1), and adjusting the antenna support arm (2), as shown.
1
Antenna Pod
HORIZONTAL LEVEL
SKY
Adjustment
Screw
Adjustment
Screw
2
Slightly loosen the adjustment screws and position the antenna so that the top of
the antenna pod is level, with the top of the pod horizontal to the sky as shown.
When the antenna is adjusted correctly, tighten the adjustment screws but be
careful not to overtighten them.
Continue with the installation procedure for your particular configuration:
Simple Configuration Installation Procedure (Single LNB, No Multi-
switch) on page 28
Before Multiswitch Configuration Installation Procedure on page 30
After Multiswitch Configuration Installation Procedure (Multiswitch
on Roof) on page 32
After Multiswitch Configuration Installation Procedure (Multiswitch
Inside Home) on page 34
—
—
—
—