Siemens SL370 - Manual (Page 62)

61
Appendix
Gigaset SL375 / AUS / A31008-M1903-C401-1-7619 / appendix.fm / 14.8.07
Ve
rs
ion 4,
16
.09.
2005
Appendix
Care
¤
Wipe the base station, charging cradle
and the handset with a damp cloth (do
not use solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.siemens.com/gigasetcustomercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
Registration or connection problems with a
Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
guide for your headset).
¥
Delete registration data from the handset
when de-registering the device (see
page 56).
¥
Repeat the registration process (see
page 56).
!
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key a .
2. The battery pack is flat.
¥
Charge/replace the battery pack
(page 7).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key # (page 10).
"Base station x" flashes on the display.
1. The handset is outside the range of the base
station.
¥
Move the handset closer to the base sta-
tion.
2. The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 12) or
reduce the distance between the hand-
set and the base station.
3. The handset has been de-registered.
¥
Register the handset (page 43).
4. The base station is not switched on.
¥
Check the base station's mains adapter
(page 7).
Base Search flashes in the display.
The handset is set to
Best Base and no base sta-
tion is switched on or within range.
¥
Move the handset closer to the base station.
¥
Check the base station's mains adapter
(page 7).
Handset does not ring.
The ringer tone is switched off.
¥
Activate the ringer tone (page 51).
You cannot hear a ringer/dialling tone from
the fixed network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong jack connections.
¥
Please always use the phone cord supplied
or ensure that the jack connections are cor-
rect when purchasing from a retailer
(page 7).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (page 58).