Test run – Woodstock M1107 User Manual

Page 12

-10-

M1107 Bench grinder

SET

Test Run

Once your machine is mounted and assembled, you should

perform a test run to make sure it works properly.

To perform a test run, do these steps:

1. Make sure all tools are removed from the grinder

area.

2. Make sure the switch is in the OFF position.

3. Plug the grinder into the power source.

4. Turn the grinder ON. Under normal conditions, the

grinder will make a humming noise, with only minor

vibration.

— If you suspect any problems, immediately turn

the grinder

OFF and refer to Page 15 to trouble-

shoot and correct any problems before starting the

grinder again.

— If the source of an unusual noise or vibration is not

readily apparent, contact our technical support

for help at (360) 734-3482 or contact us online at

DO NOT investigate problems or adjust

the bench grinder while it is running.

Wait until the machine is turned OFF,

unplugged and the spindle has come

to a complete stop before proceed-

ing!