Disconnect – Standers 580 User Manual
Page 27

Watcher™ Basics
v2.1 May.04
19
Note: A “No Service” message
appears when the AirCard 580
cannot locate the network.
1.
Click the
Connect
button to establish a connection.
Figure 4-2: Watcher in Full Mode view - Connect action button
2.
Watcher will take a few moments to connect to the
network. Once a connection is established, the dialog box
at the bottom of the Watcher window displays the word
“Connected,” notifying that a connection has been estab-
lished. The
Connect
button changes to read
Disconnect
.
Disconnect
1.
To end the current connection, click the
Disconnect
button.
Figure 4-3: Watcher in Full Mode view - Disconnect action button
2.
The dialog box returns to the “
Ready
” state, notifying that
the current session is no longer active.