Part 1: aircard 580 software installation – Standers 580 User Manual
Page 18

User Guide
10
2130374
Part 1: AirCard 580 software
installation
Windows 98 SE, Me, 2000, and XP
installation procedures
To install Watcher and the AirCard 580 drivers:
Windows 2000 & XP: You may require administrative privileges to
install the AirCard 580.
1.
The Installation CD launches automatically. Select
Install
Watcher
and a welcome window appears.
2.
Click
Next
on the
Watcher Setup Welcome
window.
3.
Use the
Next
and
Back
buttons to navigate through the
wizard noting the following:
·
You must click
Yes
to indicate your acceptance of the
terms of the license agreement to proceed with the
installation.
·
Use the default settings for the
Destination Location
and
Program Folder
unless you have special requirements and
an advanced understanding of PC configuration. (The
Destination Location
dictates where the software is
installed. The
Program Folder
dictates the name assigned
to the software in Add/Remove Programs in the Control
Panel.)
·
To customize Watcher to launch automatically each time
your notebook PC starts up, select the
Run Watcher at
Start up
check box. To add the Watcher shortcut to your
desktop, providing you with the option of launching
Watcher by double clicking an icon on your desktop (as
well as from the Start menu), select the
Desktop Shortcut
check box. (You may select both).
·
Click
Finish
to close the last screen of the wizard.
Processor
Pentium 150 MHz or higher
Memory
at least 32 MB
Disk Space
at least 14 MB
Dial-up Networking
DUN bound to TCP/IP
Table 3-1: System Resource Requirements (cont.)