Bostitch EHF1838K - Manual (Page 11)

-11-
MAINTENANCE CHECKLIST
Maintenance Benefit Procedure Service Interval
Inspect trigger performance Ensure trigger system is in
proper working order Refer to Tool Operation
Check section in this manual Daily
Drain condensation from air
compressor tanks and air
filters (if present) Prevents accumlation of
moisture that can impede tool
performace Open drain cock on tanks
and air filters and drain all
condensate Daily
Clean magazine assembly Prevents accumlation of
debris that could cause a jam Blow clean with compressed air Daily
Clean nose assembly Prevents accumlation of
debris that could cause a jam Blow clean with compressed air Daily
Ensure all fasteners remain
tight Prevent loose parts Tighten all fasteners with
appropriately sized hex
wrench Weekly
Check/clean air inlet air filter Maintains proper air flow to
engine for peak performance. Remove end cap and use
compressed air blow gun to
blow filter clean. Replace filter
as required. 25,000 Fasteners, or monthly
- if used in dusty location
Replace no-mar tip Prevents marks in softwood
applications Remove worn no-mar tip and
replace with a new tip (a spare tip
is located on the magazine) 25,000 Fasteners
Replace swivel air fitting Maintains proper air flow to
engine for peak performance Remove worn swivel air fitting
and replace with new swivel
fitting 50,000 Fasteners
Replace piston/driver
assembly Maintains consistent drive
quality Refer to replacement part kit
instructions 150,000 Fasteners
Replace O-rings Maintains engine for peak
performance Refer to replacement part kit
instructions 250,000 Fasteners
Replace bumper Maintains engine for peak
performance Refer to replacement part kit
instructions 250,000 Fasteners
Replace headvalve Maintains engine for peak
performance Refer to replacement part kit
instructions 250,000 Fasteners
Replace engine cylinder Maintains engine for peak
performance Refer to replacement part kit
instructions 500,000 Fasteners