Smeg LBS 107 - Manual (Page 8)

8 - EN
Auxiliary functions
Auxiliary Function Selection Buttons
Select the required auxiliary functions before
starting the program.
C
Some combinations cannot be selected
together. (Ex.: Pre-wash and Quick Wash.
Warning signal on the selected auxiliary
function will light up.
Auxiliary function selection
If an auxiliary function that should not be
selected together with a previously selected
function is chosen, the first selected function
will be cancelled and the last auxiliary function
selection will remain active.
(Ex.: If you want to select pre-wash first and
then quick wash, pre-wash will be cancelled
and quick wash will remain active.
Auxiliary function that is not compatible
with the program cannot be selected. (see,
“Program Selection Table”)
C
Auxiliary function buttons may differ
according to the model of your machine.
Pre-wash
A pre-wash is only worthwhile for heavily soiled
laundry. Without pre-wash you save energy,
water, detergent and time.
C
Pre-wash without detergent is
recommended for lace and curtains.
Quick wash
This function can be used for “Cottons” and
“Synthetics” programs. It decreases the
washing times for lightly soiled laundries and
also the number of rinsing steps.
Rinse Plus
With this function, you can increase the
number of current rinsing steps. Thus,
sensitive skins’ risk of being affected by the
remainder detergent on the clothes will be
decreased.
Anti-creasing
With this function, drum movement will be
lessened to prevent creasing and spinning
speed is limited. In addition, washing is carried
out at a higher water level.
C
Whenever you select this auxiliary function,
load your machine with half of the
maximum laundry specified in the program
table.
No Heat
If you wish to wash your clothes in cold water,
you can use this program.
Time display
The display shows the time remaining for
the program to complete while a program
is running. Program duration may differ
from the values in the consumption table
subject to the changes in the water pressure,
water hardness and temperature, ambient
temperature, type and amount of laundry,
auxiliary functions selected, and changes in
the supply voltage.
Time delay
With the “Time delay” function you can delay
the program start up to 24 hours. Time delay
can be set with steps of one hour for the first
three hours and with steps of three hours for
the remainder (1, 2, 3, 6, 9, …24).
1. Press “Time Delay” button to adjust the
desired time.
2. Press “Start/Pause/Cancel” button. The
time delay will start to count down.
C
More laundry may be loaded during the
time delay period.
Changing the delay time
If you want to change the time during the
countdown:
1. Press “Start/Pause/Cancel” button.
2. Press “Time Delay” button to adjust the
desired time delay.
3. Press “Start/Pause/Cancel” button.
Canceling the time delay
If you want to cancel the time delay
countdown and start the program:
1. Press “Start/Pause/Cancel” button.
2. Press “Time Delay” button to decrease the
time delay.
3. Press “Start/Pause/Cancel” button to start
the program.
Starting the Program
1. Press “Start/Pause/Cancel” button to start
the program.
2. Program follow-up lamp showing the
startup of the program will light up.
Progress of program
Progress of a running program is shown
through the program follow-up indicator. At
the beginning of every program step, the
relevant indicator lamp will light up and light of
the completed step will turn off. The symbol
that is lit up at the far right of the series of
symbols indicates the step that is being
carried out.
C
If the machine is not spinning, the
program may be in rinse hold mode or the