Warning – Scag Power Equipment GC-STWC-61 User Manual

Page 7

1. Prepare the machine so there is easy and safe

access to the work area. Remove the key and
maintain all safety related work procedures.
Always wear eye and hand protection.

2. Remove the bag assemblies from the grass

catcher.

3. Remove the rubber strap holding the adapter to

the blower assembly. See Figure 4-1.

4. Remove the belt, pin and large hair pin securing

the blower assembly to the cutter deck and
remove the blower assembly. See Figure 4-1.

FIGURE 4-1

5. Loosen the locking bolts and remove the two (2)

pins holding the hood assembly to the mounting
posts on the rear of the machine. See Figure 4-2.

BLOWER
ASSEMBLY

MOUNTING
BRACKET

ADAPTER

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

2005 GC-STC removal art 1

HAIR
PIN

4.1 GRASS CATCHER REMOVAL
INSTRUCTIONS

Remove Pins

Loosen
Locking
Bolts

FIGURE 4-2

6. With help from an assistant, remove the hood

assembly.

7. Re-install the side discharge chute to the opening

on the cutter deck. Replace the two outside
mounting bolts on the discharge chute with the
clevis pins (p/n 04064-15) and rue cotter pins
(p/n 04069-03). See Figure 4-3.

FIGURE 4-3

CLEVIS PIN
P/N 04064-15

RUE COTTER PIN
P/N 04069-03

DISCHARGE
CHUTE

GC-STC removal art 3

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING
KIT, OR ENTIRE GRASS CATCHER INSTALLED