Sanyo VCC-6975P - Manual (Page 2)

3
2
1
7
6
5
4
Direction
It is possible to narrow the target to objects moving in certain
directions only. This feature enables the system to detect people
coming into a room while disregarding people going out. It is also
possible to detect all moving objects without setting the direction.
Size
Freely set the size of target objects.
Masking
Freely establish the area where motion detection is turned off.
Magnitude of movement
Set the magnitude of movement to be detected.
Brightness
Set the lowest level of brightness to be analyzed. Use this feature
to avoid influences of electric noises on the darker area of the
screen.
Magnitude of brightness shift
Set the magnitude of changes in brightness. This feature is used
to disregard a sudden and huge change in brightness such as one
caused by turning on/off the lights.
Duration
Set the time the system should continue monitoring before identi-
fying a moving object. This feature enables the system to neglect
high speed objects such as automobiles.
1
15 10 10
5
An all-new Intelligent Digital Motion Detector is built-in to detect moving objects in the picture and send an alarm
The intelligent Digital Motion Detector analyzes changes in picture brightness on the screen and uses the direction of motion and size
of the object to identify moving objects. The system can be set to produce an external alarm signal and/or switch to a x2 digital zoom-
in display. Furthermore, the center of the zoom-in picture stays focussed on the moving object.
Reliable detection of moving objects
The intelligent Digital Motion Detector uses seven factors in analyzing changes in picture brightness to enable reliable motion detec-
tion and reduce false alarms.
An area where motion
detection is turned off
Set the direction to “right”
CAMERA 1 DIRECTION
1/3" Colour CCD
High-resolution Camera
VCC-6975P
Time
Noise
Not detection
Brightness
Shown with optional lens
*The intelligent Digital Motion Detector function is not available when the electronic
sensitivity is set to ON or when the electronic shutter is set to “long mode”.
x2 zoom x2 zoom
Intelligent digital motion detector uses size of
object and direction of motion to identify mov-
ing objects.
Display of monitor
Detection of a moving object prompts the
camera to zoom in on the object (x2), and
blinking camera ID is displayed on the moni-
tor. An external alarm signal is also sent.
Display of monitor
During the zoom-in display, the center of the pic-
ture travels and stays focussed on the object.
Duration of the zoom-in display is adjustable to
5, 10, 20, 30, and 60 seconds.
Display of monitor
CAMERA 1 CAMERA 1