Safeline Sit'n'Stroll User Manual

Page 21

Lap/Shoulder Belt with Buc

Lap/Shoulder Belt with Buckle

kle

kle T

Tongue that

ongue that

Slides Freel

Slides Freely Along Seat Belt

y Along Seat Belt

y Along Seat Belt W

Webbing

ebbing

Place the vehicle lap belt around the front of the
Sit’n’Stroll

™

and position it through the appropriate

forward-facing vehicle belt path. Click the latch plate
into the buckle.

Push down firmly on the Sit’n’Stroll

™

to sink it into

the car’s seat cushion, while pulling on the shoulder
part of the lap/shoulder belt. You may have to press
on one armrest at a time to get the auto belt tight.
Pull the seat belt as tight as possible across the unit.

Hold the lap and shoulder belts together behind the
latch plate. Unbuckle the belt while holding the belts
together.

Thread the locking clip onto both belts , placing it as
close to the latch plate as possible .

Buckle the vehicle belt again. It may be necessary
to press the Sit’n’Stroll

™

into the auto seat cushion

to get it buckled. The belt should be tight around the
restraint. If it is not, remove the locking clip and
repeat steps 1-4. If the child restraint cannot be held
tightly, move it to another seating location. If there is
not a position that will keep the child restraint
secured with a lap belt, contact your vehicle dealer
to have a lap belt installed in your vehicle.

Secure the top tether to the vehicle tether anchor if
desired.

Free sliding lap/shoulder belts have a free sliding latch

plate that does not lock to the belt. When placing the

Sit’n’Stroll™ in seating positions equipped with this

system, you must use a locking clip to prevent the seat

system, you must use a locking clip to prevent the seat
belt fr

belt fr

belt from slipping,

om slipping,

om slipping, unless it has a s

unless it has a s

unless it has a switc

witc

witchab

hab

hable retractor

le retractor

le retractor.....