Select Comfort U 3000 - Manual (Page 22)

The caps are in the Firmness Control ™ System box. Please
store these in the mattress cover in case you should ever want to
disassemble your bed and temporarily cap your air chamber(s).
Where are the caps
for air chamber(s)?
And where should
I store them?
What do I do if the
Firmness Control
™
System doesn’t run?
Make sure the power cord is securely plugged into the Firmness Control ™
System and the wall outlet. Check to see if the power cord is plugged into
an outlet that has power and is not connected to an on/off wall switch.
What if I feel like I’m
rolling toward the edge
or toward the center of
the mattress? although rare, these sensations could potentially be experienced
if one side of the mattress is set quite firm and the other side quite
soft. Call Customer Service for a remedy to this situation if it is
bothersome to you.
The odor you may smell is non-toxic and will fade over time.
To minimize the smell, allow the air chamber to air out for a few hours
and then lay a couple of dryer sheets on top of the air chamber. What if I notice a rubber
smell from the air
chamber?
20
Mattress
Frequently
Asked Questions