Sanitaire SC6070 Series - Manual (Page 9)

9
Automatic Shut-Off
NOTE: Always use the wet vacuum cleaner in the upright position. If cleaner tips
over, the suction automatically shuts off.
If the cleaner tips over:
•
Turn off the power switch and set the cleaner upright.
•
Wait a few seconds for the motor to come to a complete stop.
•
Restart the motor.
When the tank is full:
• As the tank fills with liquid, the ball float (inside the cage) rises until it seats itself
against the bottom of the motor.
•
The motor sound becomes a high pitch sound.
•
The shut-off stops the suction.
•
Turn off the power switch.
• Empty the tank (instructions follow).
HOW TO USE
(continued)
Empty Tank
CAUTION: Turn off the power switch and unplug electric cord to service.
• Lift the hose and drain any liquid back into the tank.
•
Empty contents into a suitable drain by unscrewing the drain plug. (See page 7.)
• Use special care when emptying full tanks with liquids. Quick removal of the drain
plug can result in a sudden rush of liquid.
• Replace drain plug to continue cleaning.
Begin Cleaning
With the cleaning nozzle you may begin cleaning. By pulling the trigger, you will dispense
the solution onto the desired area. Use a backstroke motion. Because the vacuum is
on, the fluid will quickly be sucked back into the wand. Make several dry passes over
the affected area to completely remove any excess moisture. You will notice that the
area you have just cleaned will be damp. This is normal.
Tips:
If used to clean up spills or messes, clean up as much of the spill or mess using paper
towels before final cleaning with the cleaner. If used on fine fabrics or upholstery, test
for color fastness in an inconspicuous place before cleaning.
Clean and Store
Note: Turn off the power switch and unplug electrical cord before cleaning tank.
• Empty tank of all liquid and thoroughly rinse inside before storing.
•
Clean and dry tank and all accessories.
• Store indoors in a cool, dry area.