Soundstream Technologies REF2.370 - Manual (Page 20)

20
SYMPTOM CHECK REMEDY
NO SOUND
Is the Status LED illuminated GREEN? NO?
Check all fuses to the amplifier
Confirm remote turn-on lead is connected at the amp and at
the radio/switched +12Volts
Clean contacts on fuse holder
Verify ground is secure
Is the Status LED illuminated GREEN? Yes?
Check gain on amp
Check source level volume
Check for Speaker or wire short
AMP NOT SWITCHING ON
No power to power wire Re-secure power cable
Poor Ground Must have bare metal ground
Does remote wire have +12V Check at source and amp
Check fuses Burnt, broken, detached?
NO SOUND ON ONE CHANNEL
Check speaker wire Look for shorts, pinches or disconnected terminal
Check RCAs
Swap left with right. If the bad side began working, the prob-
lem is before the amplifier
AMP SHUTS DOWN Check speaker load
Verify that the load does not drop below the specified ohm
level
STATUS LED IS ON - RED
Check temperature Wait for amp to cool down
Speakers shorted Check to see if it is the wire or the speakers themselves
SMOKE CAME OUT
Either you spilled your beer on it or did not read
this manual and follow the directions
Put smoke back inside
CAN’T KEEP THE OPPOSITE
SEX OFF ME
Is volume loud enough for others to hear? To avoid the opposite sex, buy a different brand of amplifier
Troubleshooting