SIIG 2S1P - Manual (Page 8)

8
Windows Vista ™
1. At the Found New Hardware window, click Locate
and install driver software (recommended), click
Continue.
2. When prompted, insert the driver CD and the driver
will install automatically.
3. At The software for this device has been
successfully installed window, click Close to
complete the installation.
Note: Driver installation may take several minutes
to complete. If your internet connection is enabled,
the driver may install automatically via Windows
Update. In this case steps 2-3 are not needed.
DOS
1. Insert the driver CD. From the C:\> prompt, type
copy X:\2S1P\dos\*.*, and press Enter. (Change
X: to match your CD-ROM drive letter)
2. Type edit autoexec.bat, and press Enter.
3. Add C:\nmdosin.exe -a at the bottom of the
Autoexec.bat file.
4. Go to File, save the changes and exit.
5. Restart your system for the new setup to take effect.