Spirit XE 850 - Manual (Page 16)

XE Series Elliptical 15
XE850 Console
Power on
The XE850 Elliptical has a built-in generator for power and does not need to be plugged into an
AC outlet. To power up the XE850 simply start to pedal, the console will turn on automatically. If
the console does not light when you pedal, check that the power switch is set to 0 (Generator).
The switch is located on the front, lower left side of the main plastic cover.
This switch should
always be set to for generator. The A.C. setting is for factory testing and dealer display
models.
When initially powered on the console will perform an internal self-test. During this time all the
lights will turn on for a short time. When the lights go off the dot matrix display will show a
software version (i.e. VER 1.0) and the message window will display an odometer reading. The
odometer reading displays how many hours the elliptical has been used and how many virtual
miles the elliptical has gone. The display shows: ODO 123 MI 123 HRS.
The odometer will remain displayed for only a few seconds then the console will go to the start
up display. The dot matrix display will be scrolling through the different profiles, showing the
programs, and the message window will be scrolling the start up message. You may now begin
to use the console.
Console Operation
Operation of Your Elliptical