Sunbeam 4059 - Manual (Page 2)

When using your flatiron, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against risk of electric shock, do not immerse the iron in water
or other liquids.
3. The iron should always be turned to “OFF” before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Retract cord into cord reel when storing.
5. Always disconnect iron from electrical outlet when filling with water or
emptying and when not in use.
6. Do not operate iron with a damaged cord’or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the iron.
Take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or
near children. Do not leave iron unattended while connected or on
an ironing board.
8. Burns can occur from touching hot metal parts, hot water or steam.
Use caution when you turn a steam iron upside down -there may be
hot water in the reservoir.
9. If the flatiron is not operating normally, disconnect from the power supply
and have the flatiron serviced by qualified service personnel.
Your Sunbeam” Iron is designed to rest on the heel rest. Do not leave the iron.
unattended. Do not set the iron on an unprotected surface, even if it is on its
heel rest.