Sony VPL EW130 - Manual (Page 28)

28
Replacing the Lamp
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
2 screws.
5
Close the lamp cover and tighten the
1 screw.
Be sure to install the lamp and Lamp cover
securely as it was. If not, the projector
cannot be turned on.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
7
Reset the lamp timer for notification of
the next replacement time.
Select “Lamp Timer Reset” on the SET
SETTING menu then press the ENTER
key. When a message appears, select
“Yes” to reset the lamp timer (page 19).
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the
Telecommunications Industry
Association (www.eiae.org).
Note
Caution