Sanyo PLC-SU31 - Manual (Page 11)

CONTROL PORT
USB
RESET
Y – Pb / Cb – Pr / Cr R – AUDIO IN – L (MONO)
S – VIDEO
COMPUTER IN MONITOR OUT
EXT.SP(8 Ω)
(STEREO)
AUDIO IN
COMPUTER
VIDEO
11
CONNECTING PROJECTOR
TERMINALS OF PROJECTOR
When controlling the computer
with Remote Control Unit of
this projector, connect the
mouse port of your personal
computer to this connector.
(Refer to P12.)
Connect the S-VIDEO
output from video
equipment to this
jack. (Refer to P13.)
Connect the audio output
(stereo) from computer to
this jack. (Refer to P12.)
Connect the audio output
from video equipment to
these jacks.
(Refer to P13.)
● When the audio output
is monaural, connect it
to L (MONO) jack.
CONTROL PORT CONNECTOR
COMPUTER AUDIO
INPUT JACK
AUDIO INPUT JACKS VIDEO INPUT JACKS S-VIDEO INPUT JACK
Connect the composite video
output from video equipment
to VIDEO/Y jack or connect
the component video outputs
to VIDEO/Y, Pb/Cb and
Pr/Cr jacks. (Refer to P13.)
Connect a computer output
to this terminal.
(Refer to P12.)
COMPUTER INPUT
TERMINAL
This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on
pages 11 to 13 and connect properly.
Connect an external
speaker system to this jack.
(Refer to P12, 13)
EXTERNAL SPEAKER JACK
This projector uses a micro
processor to control this unit,
and occasionally, this micro
processor may malfunction
and need to be reset. This
can be done by pressing
RESET button with a pen,
which will shut down and
restart the unit. Do not use
RESET function excessively.
RESET BUTTON
When controlling the computer
with Remote Control Unit of
this projector, connect USB
port of your personal computer
to this connector. (Refer to
P12.)
USB CONNECTOR (Series B)
Connect a monitor to this
terminal. This terminal
outputs a computer input
signal. (Refer to P12.)
MONITOR OUTPUT
TERMINAL