Appendix, Care, Contact with liquid – Siemens Gigaset E45 User Manual

Page 19: Questions and answers, Care contact with liquid questions and answers

Appendix

Gigaset E45 / English / A31008-M1751-R201-1-SM19 / start_guide_time.fm / 04.08.2005

Appendix

Care

Wipe the charging cradle and the hand-

set with a damp cloth (do not use sol-

vent) or an antistatic cloth.

Never use a dry cloth. This can cause

static.

Contact with liquid

Your handset is splash proof.
If it comes into contact with water, knock

the water out of the microphone opening

and remove any water on the handset

with an absorbent cloth. Your handset is

ready for use.
If your handset comes into contact with a

larger amount of liquid take the following

steps:
1. Do not switch the handset on under

any circumstances!

2. Remove the battery pack immediately.
3. Remove the headset socket cover.
4. Hold the handset horizontally with the

open battery compartment facing

down.

5. Hold the handset vertically. Tilt the

handset backwards and forwards

slightly, giving it a gentle shake each

time.

6. Dab all parts dry and then leave the

handset for at least 72 hours with the

battery compartment open and the

keypad facing down in a dry, warm

place (not: microwave, oven or similar).

When it has fully dried out, you will nor-

mally be able to use it again.

Questions and answers

If you have any queries about the use of

your telephone, you can contact us at any

time at www.siemens.com/gigasetcus-

tomercare . The table below contains a list

of common problems and possible solu-

tions.

The display is blank.
1. The handset is not switched on.

Press and hold the end call key

2. The battery pack is flat.

Charge/replace the battery pack

(page 4).

The handset does not respond to a key press.
The keypad lock is activated.

Press and hold the hash key

(page 8).

"Base station x" is flashing in the display.
1. The handset is outside the range of the base

station.

Reduce the distance between handset/

base station.

2. The handset has been de-registered.

Base Search is flashing in the display.
Handset is set for

Best Base

and no base station

is within range.

Reduce the distance between handset/base

station.

Handset does not ring.
The ringtone is switched off.

Activate the ringtone (page 16).

The other party cannot hear you.
You have pressed the

(INT) key. The hand-

set is "muted".

Switch on the microphone again (page 8).

You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.

Repeat the operation.
Watch the display and refer to the operating

instructions if necessary.