SEAL AQUA AS-1600 - Manual (Page 6)

Safety Information
5
General
q Do not operate the machine until it is connected to the proper power source.
Refer to Installation instructions located inside control cabinet.
q It is strongly recommended that the machine is fed from an “Earth Leakage”
protected electrical outlet – if in doubt, please contact Hunt Technical Services
(contact details in “Miscellaneous” section at the rear of the manual) or consult a
licensed electrician.
q Familiarize yourself with the layout of the Control Panel, and with the operation of
the sealant delivery system.
q Do not wear loose clothing, and contain loose hair to avoid becoming entangled
with moving parts of the machine.
q Comply with all safety warning signs, labels, and instructions.
q Operators should be trained on the proper use of the machine and all safety
procedures.
q Provide fresh water, clean towels and rubber gloves for use during cleanup.
q It is advisable to wear eye protection when filling/emptying sealant tank. Always
Provide an approved emergency eyewash station adjacent to the machine.
Figure 1 shows the safety labels that appear on the AquaSEAL™ AS-1600.
Figure 1. Safety Labels
Emergency Stop Labels
Rotating Parts Warning Labels
High Voltage Warning Label
Temperature Warning Labels