Sears 200.71233 - Manual (Page 5)

4
Attach Foot:
Remove charger from packing materials and place
charger face down. Attach mounting foot and secure
with the two, 1/4-20 thread cutting screws provided.
continued on next page
Before Using Your Battery Charger
It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground
and connect the power cord, and prepare to charge a battery.
Assembling your charger
It is important to fully assemble your charger before use.
Follow these instructions for easy assembly.
PARTS: TOOLS NEEDED:
Two, 10-32 thread cutting 3/8" wrench
screws (for mounting foot)
Two, 1/4-20 thread cutting 5/16" wrench
screws (for wheels)
Two wheels Hammer
One axle Screwdriver
(for handle assembly)
Two axle caps
Two axle brackets
One handle
One handle grip
One mounting foot
Axle Assembly:
Hold axle upright on floor or work surface. Then, using
a hammer, tap one of the axle caps onto
the top end of the axle. Be sure to tap the hub on
straight. Slide both wheels onto the axle with the
hubs facing inward. Tap the other axle cap onto the
opposite end of the axle and place the axle assembly
onto the bottom of the charger.