Shindaiwa 89303 - Manual (Page 10)

10
NEVER
Ŷ
VPRNHRUOLJKW¿UHVQHDUWKH
engine.
ALWAYS
Ŷ
stop the engine and allow
it to cool before refueling.
ALWAYS
Ŷ
Wipe all spilled fuel and
move at least 3 meters (10 feet) from
the fueling point and source before
starting.
NEVER
Ŷ
SODFHÀDPPDEOHPDWHULDO
FORVHWRWKHHQJLQHPXIÀHU
NEVER
Ŷ
operate the engine without the
PXIÀHUDQGVSDUNDUUHVWHUVFUHHQLQ
place and in good working condition.
FUEL IS HIGHLY FLAMMABLE.
Ŷ
ALWAYS
Ŷ
store gasoline in a con-
WDLQHUDSSURYHGIRUÀDPPDEOHOLTXLGV
ALWAYS
Ŷ
inspect the unit for fuel
leaks before each use. During each
UH¿OOFKHFNWKDWQRIXHOOHDNVIURP
around the fuel cap and/or fuel tank. If
fuel leaks are evident, stop using the
unit immediately. Fuel leaks must be
repaired before using the unit.
ALWAYS
Ŷ
move the unit at least 3
meters (10 feet) away from a fuel
VWRUDJHDUHDRURWKHUUHDGLO\ÀDP-
mable materials before starting the
engine.
Mixing fuel
Filling the fuel tank
CAUTION!
This engine is designed to operate on
a 50:1 mixture consisting of unleaded
gasoline and ISO-L-EGD or JASO FD
class 2-cycle mixing oil only. Use of
non-approved mixing oils can lead to
excessive carbon deposits.
Use only fresh, clean unleaded gasoline
Ŷ
with a pump octane of 87 or higher.
Mix all fuel with a 2-cycle air-cooled
Ŷ
mixing oil that meets or exceeds ISO-L-
EGD and/or JASO FD classified oils at
50:1 gasoline/oil ratio.
Examples of 50:1 mixing quantities
WARNING!
Minimize the Risk of Fire
IMPORTANT!
Mix only enough fuel for your immediate
needs! If fuel must be stored longer than 30
days and
oil with fuel stabilizer is not
used, it should first be treated with a fuel
stabilizer such as STA-BIL™.
Oil is a registered JASO FD classi-
fied oil and also meets or exceeds ISO-L-EGD
performance requirements. Shindaiwa One is
recommended for use in all Shindaiwa low emis-
sions engines. Shindaiwa One also includes a
fuel stabilizer.
Mixing fuel
CAUTION!
Never use any type of gasoline con-
taining more than 10% alcohol by vol-
ume! Some types of gasoline contain
alcohol as an oxygenate. Oxygenated
gasoline may cause increased operat-
ing temperatures. Under certain con-
ditions, alcohol-based gasoline may
also reduce the lubricating qualities of
some 2-cycle mixing oils.
Generic oils and some outboard
oils should never be used in your
Shindaiwa engine.
Place the unit on a flat, level surface. 1.
Clear any dirt or other debris from 2.
around the fuel filler cap.
Remove the fuel cap, and fill the tank 3.
with clean, fresh fuel.
Reinstall the fuel filler cap and tighten 4.
firmly.
Wipe away any spilled fuel before start- 5.
ing engine.
CAUTION!
Slowly remove the fuel cap only after
stopping the engine
CAUTION!
Mix and pour fuel outdoors where
WKHUHDUHQRVSDUNVDQGÀDPHV
U.S. METRIC
Gasoline
2-cycle
mixing oil
Gasoline
2-cycle
mixing oil
US Gallons Fl.oz. Liter cc.
1 2.6 4 80
2 5.2 8 160
5 13 20 400
10 25.6 30 600
20 51.2 50 1000
50 128 100 2000