Concrete surface – SIIG 04-0600A User Manual
Page 10
10
4.
With the anchors in place, mount the wall plates
using the ST5.5 x 45 self tapping screws, see
Figure 8
below.
Figure 8
ST5.5 x 45 Self
Tapping Screw
Insert screw through wall plate
and into the alligator anchor
Insert Alligator
Anchor
Pre Drill 5/16"
Holes
Concrete Surface
1.
Using the wall plate as a template, mark hole
positions on the mounting surface. For in-wall
applications, position the mounting holes in a vertical
pattern, see Figure 9 on the next page.
2.
Drill holes in the solid concrete or hollow block
using a 5/16" masonry bit. Once the holes are
drilled, insert the # 12-14 alligator anchors into the
holes and make sure the anchor is flush with the
surface of the wall, see Figure 9 on the next page.