Siemens AG AT18 - Manual (Page 6)

6
Condensed Operating Manual for Door Control Unit AT8
7 Parameter setting with terminal module or user terminal
The terminal module (option) or the user terminal can equally be used for the diagnosis and setting of
the parameter. The buttons of the tools have identical designations and significance.
Accept key, jump to next menu below
Escape key, jump back to menu above
Menu selection key, increase of a parameter value
Menu selection key, reducing of a parameter value
The taking over/acceptance of an adjusted parameter always takes place in the door position “CLOSE”.
Menu of the HT18:
ESC
Jump to
RESET
SIEMENS AT8
USER TERMINAL
LANGUAGE-MENU
German
LANGUAGE-MENU
English
MAIN-MENU
Total alignment
MAIN-MENU
Quick alignment
MAIN-MENU
Monitor
MAIN-MENU
Service
SERVICE-MENU
FW version
SERVICE-MENU
Fault/Status
SERVICE-MENU
Maintenance
SERVICE-MENU
Special
MONITOR-MENU
Door status
MONITOR-MENU
Input signals
MONITOR-MENU
Output signals
QUICK-MENU
Door status
QUICK-MENU
Profile selection
QUICK-MENU
Movement instructions
QUICK-MENU
Parameter setting
Profile parameter
Movement instructions
Start teach-in drive
with standard profile
Start teach-in drive
Load
Standard profile
Standard
op
tional