Replacing starter rope and rewind spring – Solo USA MS 270 User Manual
Page 50
49
MS 270, MS 270 C, MS 280, MS 280 C
English / USA
:
Remove the screws (1).
:
Push the hand guard upward.
:
Pull the underside of the fan cover
away from the fan housing and
remove it downward.
:
Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
:
Carefully remove the rope rotor
with washer (3) and pawls (4) – do
not pull the rewind spring out of the
housing – take care to avoid injury.
Starter Grip without ElastoStart
:
Use a screwdriver to pry the rope
out of the starter grip.
:
Remove the remaining rope from
the rotor and grip.
:
Thread the new rope through the
starter grip and tie a simple
overhand knot.
:
Pull the knot back into the grip.
Starter Grip with ElastoStart*
:
Ease the cap (5) out of the starter
grip.
:
Remove the remaining rope from
the rotor and grip.
:
Thread the new rope through the
starter grip and tie a simple
overhand knot.
:
Pull the knot back into the grip.
:
Refit the cap in the grip.
*
see “Guide to Using this Manual”
Replacing Starter Rope
and Rewind Spring
1
1
1
1
1
146BA017 KN
4
4
3
2
001BA096 KN
146BA020 KN
5
135BA000 KN
146BA018 KN