Air conditioner features(continued), Button, Timer button – Soleus Air SG-TTW-10HC User Manual

Page 9

with multifunction; For some function, which the model dosen't have, if press the
corresponding button on the remote controller that the unit will keep the original

running status.

Notice: This is a general use remote controller, it could be used for the air conditioners

Remote control

●

+ button

●

Presetting temperature can be decreased.

Press this button, the temperature can be

- button

set up, continuously press this button

and hold for two seconds, the relative
contents can quickly change, until unhold
this button and send the order that the ℃
(

signal will be displayed all the time.

The temperature adjustment is unav-

ailable under the Auto mode, but the order

can be sent by if pressing this button.

For presetting temperature increasing.

Press this button,can set up the temperature,

when unit is on . Continuously press and

hold this button for more than 2 seconds,
the corresponding contents will be
changed rapidly, until unpress the button

laying all along. In Auto mode, the temp-

erature can not be set up, but operate this

button can send the signal. Centigrade

setting range :16-30; Fahrenheit scale

setting range 61-86.

then send the information,

is disp-

●

By pressing this key under switch-off state,

you may set the time for auto switch-on. The

TIMER button

TIMER

range of setting is 0.5 ~ 24 hours. The

characters "T-ON" and "H" will flash for 5
seconds. Within 5 seconds,you may make
one press of this key to complete the setting
and send the message.If the setting is valid,
the set time will be displayed for 2 seconds

before display of the temperature message.
During flash, you may press "+" key to
increase the value and press "-" key to decrease
the value. The time will increase or decrease

by 0.5 hours with each press of this key.
If pressing "+" or "-" key continuously, the
time value will change rapidly. The remote
controller can increase the set time by 0.5
hours every 0.25 seconds. After being

energized, the fault is no timer setting, and

there is no display of "T-ON" or "H". Press

ON/OFF key to switch on the unit and cancel

the auto switch-on.When the temperature
display becomes constant, you may press

this key again to display the remaining set
time. The time value, "T-On" and "H" will

display constantly for 2 seconds. After 2
seconds,the preset temperature will be
displayed. Within these 2 seconds, you may
press this key again to cancel the auto
switch-on and send the message.

By pressing this key under switch-on state,

you may set the time for auto switch-off.

The method of setting as the same as for

auto switch-on.

●

C( F)

Air Conditioner Features(continued)