Sub-Zero 315 - Manual (Page 12)

Knock-out
12
Hinge Cover Installation
This is to be completed after the unit is fully installed.
IMPORTANT NOTE: Install the 90 degree stop prior to
installing the hinge covers.
1) Remove the backing paper of the adhesive pads and
bond to the hinge as shown in the illustration.
IMPORTANT NOTE: Hinges must be free of dirt or grease
before applying covers.
2) Install center covers as shown in the illustration (mag-
nets will secure these covers).
IMPORTANT NOTE: It will be necessary to remove the
knock-out in this cover when the 90˚ door stop is used.
INSTALLATION
90 Degree Door Stop
Model 315 has a 90 degree door stop. Follow these steps
for installation:
1) Open door to 80 degrees.
2) Insert stop pin into the bottom door hinge (pin enters
from the top). Refer to the illustration below.
3) Pin must be driven until head has made contact with
the hinge body.
4) Insert stop pin into the top door hinge (pin enters from
the bottom).
5) Pin must be driven until head has made contact with
the hinge body.
6) Check for proper operation.
7) Install hinge covers if installation is complete.
Hinge Cover Installation
HIGH
LOW
NORMAL
OFF
ICE LEVEL CONTR
OL
Stop Pin
90 Degree Door Stop