Samson A35 - Manual (Page 8)

6
A. AC Power Inlet - Use the supplied grounded AC power cord to connect your A Series
amplifier to mains power. This cord comes supplied with the appropriate plug for your
geographic area. CAUTION: Do not use an adapter to defeat the third grounding pin on
this plug or severe electric shock may result!
B. Speaker Output – The jack is used to connect the internal 8-ohm aluminum driver.
C. Direct Output - This standard, balanced XLR connector provides a Line-level pre-EQ
and pre-Volume output signal from the A Series amplifier. You’ll usually use this to con-
nect the A Series signal to a Line-level input when interfacing with PA systems or record-
ing mixing consoles.
D. Preamp Out (Effects Loop Send )- Use this 1/4" unbalanced jack to send signal to a pro-
fessional outboard effects processor.* Output level is approximately 0 dB to +4 dB and is
post-EQ and post-Shape but unaffected by the setting of the Volume control. The signal
from this output is the same as that from the Direct Out on the rear panel.
E. Amp In
(Effects Loop Return)- Use this 1/4" unbalanced jack to return signal from a pro-
fessional outboard effects processor.*
* In-line effects (such as footpedals) intended for low signal levels should be placed
between your bass and the front panel A SERIES amplifier Input and not connected with
the rear panel Effects Loop jacks.
Guided Tour - Rear Panel
25 WATT BASS AMPLIFIER
EFFECTS LOOP
PREAMP
OUT
AMP IN
CAUTION
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE ATTENTION
UTILISER UN FUSIBLE DE RECHANGE DE MÊME TYPE
WARNING
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE AVIS
RISQUE DE CHOC ELECTRONIQUE NE PAS OUVRIR
SERIAL
NUMBER
MADE IN CHINA
DIRECT OUT SPEAKER
OUT
DESIGNED AND ENGINEERED IN THE UNITED STATES BY HARTKE
A25
www.hartke.com
8 OHM
115 VAC
230 VAC 2A
1A
A B C D E