Samsung digimax U-CA 501 - Manual (Page 31)

31
+/- button
ISO: You can select the ISO sensitivity when taking pictures.
The speed or specific light-sensitivity of a camera is rated by ISO numbers.
Selecting an ISO Sensitivity
1. Press the +/- button, and then use the UP and DOWN
buttons to select the ISO icon( ). The ISO menu bar
will appear as shown.
2. Use the LEFT and RIGHT buttons to select the desired
ISO sensitivity value.
- AUTO : The camera's sensitivity is
automatically changed by variables
such as lighting value or subject brightness.
- 100, 200, 400 : You can increase the shutter speed while the same amount of light is
present, by increasing the ISO sensitivity. However, the image may be
saturated in high luminance. The higher the ISO value, the higher the
camera’s sensitivity to light is and therefore the greater its capacity to take
pictures in dark conditions. However, the noise level in the image will
increase as the ISO value increases, making the image appear coarse.
3. When you press the +/- button again, the value you set will be saved and ISO setup mode
will end.
Using the Custom White Balance
White balance settings may vary slightly depending on the shooting environment.
You can select the most appropriate white balance setting for a given shooting environment by
setting up the custom white balance.
1. Select the CUSTOM ( ) menu of the White Balance
and press the OK button.
2. Place a sheet of white paper in front of the camera so that
the LCD monitor shows only white, and then press the
SHUTTER button.
3. Press the OK button and your custom white balance value
is stored.
- The custom white balance value will be applied, starting
with the next picture you take.
- The user configured white balance will be remain
effective until it is overwritten.
[ White paper ]