Spin Master Air Hogs Skywinder User Manual
Page 2
STEP 1
CHARGING YOUR SKYWINDER
TM
IMPORTANT CHARGING TIPS
STEP 3
STEP 5
STEP 2
STEP 4
SETTING UP YOUR SKYWINDER
TM
FOR INDOOR TRAINING
STEP 1
STEP 2
Ensure that the ON/OFF
SWITCH on the plane
and the charger are
“OFF”.
Insert the
CHARGE NOZZLE
into the plane’s
CHARGING PORT.
Start charging by switching the
charger’s ON/OFF SWITCH to “ON”.
Let the plane charge for 5 minutes.
NOTE: The CHARGING LIGHT
on the charger will blink red
during charging. When charging
is complete, the READY LIGHT
will turn to a solid green.
ON/OFF
Switch
ON/OFF
Switch
Charging Port
Charge Nozzle
Turn the ON/OFF
SWITCH on charger to
“OFF”.
Unplug the CHARGE
NOZZLE from the plane’s
CHARGING PORT.
NOTE: You are now ready
to set up your SkyWinder™
for indoor training.
Unlock the TRAINING
STAND and lift it until
it is vertical with the
CHARGER BASE.
Carefully place the plane’s
TRAINING STAND PORT onto
the TRAINING STAND ROD.
Training
Stand
PLANE
CHARGER
Ready
Light
Charging
Light
Training
Stand
Training
Stand
Port
IMPORTANT: BEFORE YOUR FIRST FLIGHT, YOU MUST CHARGE AND DISCHARGE YOUR AIRPLANE FULLY 1 TIME.
YOU MUST ALSO REPEAT THIS STEP WHEN A PROLONGED PERIOD OF TIME HAS PASSED WITHOUT FLYING.
FAILURE TO DO THIS WILL RESULT IN SHORTENED LIFESPAN FOR YOUR AIRPLANE. FOR ALL OTHER FLIGHTS,
CHARGE THE BATTERIES ONCE ONLY. DO NOT OVERCHARGE THE BATTERIES AS THIS WILL PERMANENTLY
DAMAGE THE BATTERIES.
By following these charging tips, your SkyWinder™
plane’s batteries lifespan is extended.
• After each flight, switch off the plane.
• Before storing the plane for a long period of time, fully charge
your plane and switch the plane off.
• Prior to flying in cold weather, store the plane in an indoor
area with a temperature above 68°F/20°C.
• If the battery condition (completely drained or fully charged)
is unknown, drain the battery fully by turning the plane on
until the plane’s rotors stop moving.
• Do not charge the plane’s batteries more than twice at a
time. If the battery power is weak, drain the batteries by
leaving the plane on. Rest the plane for 1 minute before
recharging the battery.