Sherwood RD-8504 User Manual
Page 48
E
N
G
L
IS
H
48
• Loud test tones are output successively and then if a series of auto setup procedure has been completed, "COMPLETED"
will be displayed.
• To stop the auto setup procedure while performing it, press the CURSOR LEFT button.
In such a case that the auto setup procedure is stopped before "COMPLETED" is displayed, the results of each adjustment
can not be memorized.
• If there may be a problem with speaker or microphone connection, error message will be displayed. In this case, turn off the
power, check the connection and then retry the auto setup procedure.
■Notes :
• Because the test tones are loud, ensure there no infants or small children in the room.
• For best results, ensure the room is as quiet as possible during the auto setup procedure.
If there is too much ambient noise, the results may not be satisfactory.
When the auto setup has been completed.
Continued
2.
Press the CURSOR UP/DOWN buttons to select the Auto Setup, then press the CURSOR RIGHT button.
3.
Press the CURSOR RIGHT button to start the auto setup procedure.
4.
To memorize the results, press the CURSOR RIGHT button.
• Then the results are memorized and the Speaker/Room EQ Setup menu is displayed.
• When the CURSOR LEFT button is pressed to select “CANCEL”, the results are not memorized.
• Check the results on each setup menu(Speaker Configuration menu on page 50, Speaker Crossover menu on page 51,
Speaker Distance menu on page 52 and Channel Level menu for "Calibrate" mode) on page 53).
• If the results are not satisfactory, you can retry the auto setup procedure or personalize your speaker setup and channel
level setup by making the settings manually. (For details, refer to "When selecting the Speaker Configuration" on page 50,
"When selecting the Speaker Crossover" on page 51, "When selecting the Speaker Distance" on page 52 and "When
selecting the Channel Level" on page 53.)
Before starting the system,
please plug the MIC. in using
the front panel jack.
<
The test tone is LOUD.
BACK
NEXT
COMPLETED
CANCEL
APPLY
RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18오 6:41페이지48