Sony J-H1 - Manual (Page 24)

Chapter 4
Playback
Chapter 4 Playback
4-3
4-2 Playback Procedures
4-2-1 Normal Playback
In jog mode, the JOG dial controls the playback speed
based the speed at which the dial is turned. The
playback speed range is ±1 times normal speed.
Use the following procedure to carry out playback in
shuttle mode.
1
Turn the JOG dial directly or press the JOG/
SHUTTLE button to light the JOG indicator.
Pressing the JOG/SHUTTLE button toggles
between jog mode and shuttle mode.
2
Turn the JOG dial in the desired direction, at a
speed corresponding to the desired playback speed.
Playback in jog mode starts.
3
To stop playback in jog mode, stop turning the
JOG dial.
It is possible to make pressing the JOG/SHUTTLE
button to switching between JOG and SHUTTLE
mode.
Select “KEY” in SELECTION FOR JOG/
SHUTTLE DIAL ENABLE, extended menu item
101, to enable the above feature. (This is the
default setting.)
SHIFT button
4-2-2 Playback in Jog Mode
Insert a cassette beforehand.
For details of how to insert a cassette, see “Inserting and
ejecting cassettes” on page 3-2.
To start playback
Press the PLAY button.
To stop playback
Press the STOP button.
If you play back to the end of the tape
The tape is automatically rewound, and stops.
(When AUTO REWIND, extended menu item 125, is
set to ENA)
Note
This unit uses an auto-tracking function. The factory
setting for the auto-tracking is on (AUTO TRACKING
ON). You can turn auto-tracking off. For details on
how to change the setting, contact your nearest Sony
dealer. While this unit is pulling the tape in, the PLAY
button indicator B flashes.
1
1,2,3
Cassette compartment
AU MON SEL button
PLAY button
STOP button