Schumacher AUTOMATIC BATTERY CHARGER XC75 User Manual

Page 10

•

XC103

BATTERY SIZE/RATING

CHARGE RATE/CHARGING TIME

3 AMP

5 AMP

12 - 30

AMP

SMALL

Motorcycle,

garden,

tractor, etc.

6 - 12 AH

1¼ - 2½ hrs

¾ - 1½ hrs

12 - 32 AH

2½ - 6¾ hrs

1½ - 4 hrs

CARS/

TRUCKS

200 - 315 CCA 40 - 60 RC

7½ - 9½ hrs

4½ - 5¾ hrs

45 min - 2½

hrs

315 - 550 CCA 60 - 85 RC

9½ - 12¼ hrs

5¾ - 7½ hrs

1 - 3 hrs

550 - 1000

CCA

80 - 190

12¼ - 23¼ hrs

7½ - 14 hrs

1¼ - 5 ¾

hrs

MARINE/DEEP CYCLE

80 RC

11¾ hrs

7 hrs

1¼ - 3 hrs

140 RC

18 hrs

10¾ hrs

1¾ - 4½ hrs

160 RC

20 hrs

12 hrs

2 - 5 hrs

180 RC

22 hrs

13¼ hrs

2¼ - 5½ hrs

MAINTENANCE INSTRUCTIONS

13.

After use and before performing maintenance, unplug and disconnect the battery

13.1

charger (see sections 6, 7 and 8).
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the terminals,

13.2

cords, and the charger case.
Ensure that all of the charger components are in place and in good working condition,

13.3

for example, the plastic boots on the battery clips.
Servicing does not require opening the unit, as there are no user-serviceable parts.

13.4

All other servicing should be performed by qualified service personal.

13.5

MOVING AND STORAGE INSTRUCTIONS

14.

Store the charger unplugged, in an upright position. The cord will still conduct electricity

14.1

until it is unplugged from the outlet.
Store inside, in a cool, dry place (unless you’re using an on-board Marine Charger).

14.2

Do not store the clips on the handle, clipped together, on or around metal, or clipped to cables.

14.3

If the charger is moved around the shop or transported to another location, take care to

14.4

avoid/prevent damage to the cords, clips and charger. Failure to do so could result in

personal injury or property damage.
TROUBLESHOOTING AND FAILURE CODES

15.

Failure Codes

FAILURE

CODE

DESCRIPTION

CAUSE

F01

The battery voltage is still

under 10V (for a 12V battery)

or 5V (for a 6V battery) after

2 hours of charging.

Could be caused by trying to charge a 6

volt battery on the 12 volt setting, or the

battery could be bad; have it checked or

replaced.

F02

The charger cannot

desulfate the battery.

The battery could not be desulfated;

have it checked or replaced.

F03

The battery was unable

to reach the “full charged”

voltage.

Could be caused by trying to charge a

large battery or bank of batteries on too

low of a current setting, or the battery

may have a shorted cell. Try again with

a higher current setting, or have the

battery checked or replaced.