Star Micronics PR921-24-A - Manual (Page 6)

– 3 –
3. PAPER SPECIFICATIONS (HEAT SENSITIVE PAPER)
(1) Paper Width : 79.5
±
0.5 mm to 111.5
±
0.5 mm
(2) Allowable Sheet Length : 75 to 300 mm
(3) Recommended Heat Sensitive Paper : According to product specifications for TMP942-24-A.
(4) Paper Thickness : 0.065 mm to 0.150 mm
(5) Shaft Core Diameter : When paper thickness is Min. 0.065 mm to 0.10 mm
Shaft core inner diameter: Min. 25.4
±
1 mm;
Shaft core outer diameter: Min. 31.4
±
1 mm
When paper thickness is Min. 0.10 mm to 0.15 mm
Shaft core inner diameter: Min. 50.8
±
1 mm;
Shaft core outer diameter: Min. 56.8
±
1 mm
(6) Paper Curl Direction : Set the paper so that the printing side is facing the outside when taken up
on the roll.
Note 1: Paper jams can occur if paper outside of the specifications describe above is use.
(7) Non-printing Region on Back Side :
Note 2: When using paper outside of the specifications describe above, the paper
detector(sensor) may mis-detect the paper or may not detect the paper at all.
25 mm
10 mm
Paper back side
Non-printing region (Back side)
The front side of the
paper is the printing surface.
Paper discharge direction
79 mm
(Minimum paper width)
112 mm
(Maximum paper width)
Center of presenter paper discharge outlet