StarTech.com PCI4S9503V - Manual (Page 8)

6
DOS
When installing multiple cards in DOS, it is important to install the card designated card
Number 1 (with the jumper ON) first.
1. Change your active directory to the target directory:
ex: c:\RAYON
2. Insert the driver disk into the disk drive and copy the DOS files from the driver
diskette:
ex: xcopy /s/e/v a:\DOS\*.*
3. Run the driver installation command:
ex: c:\rayon\pciport
4. The cards will now be installed in your system. Each card will show the card number
in the system (for the application to specify the target card and target port), the card
model, the card jumper setting (for card number 1 or 2), the IRQ assigned, and the
COM port number for the card.
You may see the following error messages:
• PCIPORT already installed. This means the driver has already been installed.
• Please check the “JP1”. This means that both cards in the system have their jumpers
ON.
• PCIPORT not in system. There is no card in the PCI slot.
Notes:
• The driver function call description can be found on the DOS driver diskette. There is
also a DEMO program for the user to meet their target application program.