Assembly instructions – Stamina Products Inmotions User Manual

Page 7

ASSEMBLY INSTRUCTIONS

STEP 3:

Place the

BASE FRAME(1)

between the

LEFT

and

RIGHT UPRIGHTS(2, 3)

and secure

with

HEX BOLTS(M12 x 70mm)(39)

and

WASHERS(M12)(48). DO NOT TIGHTEN COMPLETELY.

STEP 4:

Secure the

U-SHAPED HANDRAIL(5)

onto the

LEFT

and

RIGHT UPRIGHTS(2, 3)

with

BUTTON HEAD BOLTS(6mm x 15mm)(40)

and

ARC WASHERS(M6)(44).

Connect the

UPPER

EXTENSION WIRE(28)

to the

LOWER EXTENSION WIRE(29).

STEP 5:

Go back and tighten

HEX BOLTS(M12 x 70mm)(39)

STEP 2.

Connect the

LOWER

EXTENSION WIRE(29)

located on the

LEFT UPRIGHT(2)

to the

SENSOR WIRE(30).

Insert the

PULL PIN(9)

through the

RIGHT UPRIGHT(3)

and

BASE FRAME(1)

to lock the

BASE FRAME(1)

position.

STEP 6:

Install two "AA" batteries into the

METER(26),

two batteries included. See page 8 for detailed

battery installation instructions. Slide the

METER(26)

onto the plate on the

U-SHAPED HANDRAIL(5).

Connect the

UPPER EXTENSION WIRE(28)

to the

METER(26).

STEP 7:

Attach the

BUMPER STANDS(22)

to the bottom of the

BASE FRAME(1).

NOTE:

The

BUMPER STANDS(22)

may be stored on the end of the

BASE FRAME(1)

to increase the

angle of the treadmill and reduce the walking resistance. See page 10 for details on adjusting the walking
resistance.