Sanyo CLT-A5822 - Manual (Page 19)

19
and not a pause. Each pause counts as 1 digit in the dialing sequence. Or
you can store redial number in the directory by pressing REDIAL (Note: If the
redial number is longer than 24 digits, it cannot be stored into the memory.).
8. Press MEM again to store the number to memory. If you are replacing a
number, “REPLACE MEMO?” shows on screen. Press MEM again to confirm,
or press *TONE/EXIT to return to standby mode.
To view your directory, press MEM and use CID/VOL
or or the number
(0-9) to scroll.
Replacing a directory entry with a Caller ID entry
Use the same procedure as for storing Caller ID entries in the directory
Changing a stored number
Use the same procedure as for storing a number in the directory
Making calls from the directory
1. Make sure the phone is ON by pressing TALK.
2. Press MEM.
3. Press the number (0 - 9) for the desired memory location. The number dials
automatically.
Or:
1. Make sure the phone is OFF (not in TALK mode).
2. Press MEM.
3. Press the number (0-9) or use CID/VOL
or to select the desired
number.
4. Press TALK, the number will be dialed automatically.
Reviewing and deleting directory contents
1. Make sure the phone is OFF (not in TALK mode).
2. Press MEM.
3. Use CID/VOL
or to scroll through the directory until the desired name/
number is shown, or use the number pad to select a memory location. The
selected telephone number and name show on screen.
4. While the entry is displayed, press CH/DEL to delete the entry. The screen
shows “DELETE?”
5. Press CH/DEL again to delete the entry. “DELETED” shows on screen.
DIRECTORY
sy5822 10 april.p65 2006/5/12, ¤U¤И 02:52 19