Sanyo Vizzon HT27546 - Manual (Page 5)

5
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
FIRST-THINGS-FIRST (REQUIRED INITIAL SETUP)
The signal makes the difference!
1 INITIAL SIGNAL CONNECTIONS
Analog RF Antenna Connection
• Connect a Cable signal (with or without a cable
box) or RF antenna to the Analog RF input.
The analog tuner in this DTV receives Analog
Antenna signals, Analog Cable signals, or the RF
output from a VCR or cable box.
CATV FRANCHISE NOTE: Cable
companies, like public utilities,
are franchised by local govern-
ment authorities. To receive
cable programs, even with
equipment which is capable of
receiving cable channels, the
consumer must subscribe to
the cable company’s service.
■
DTV will select the correct Antenna mode for the type of Analog RF
signal connected automatically.
■
Use “Ana (Analog) Antenna Signal” in the Setup menu to change
the Antenna Mode.
■
If you move the DTV to a new location, press the RESET key twice
after connecting the signal and turning on the DTV.
Analog Cable RF
Antenna
Cable
Box
DTV Back
VCR Back
NOTES: If you do not have a VCR, connect signal directly
to the 75 ohm terminal (UHF/ VHF/ CATV).
The only resolution available with any of these
connections, regardless of the original content, is
standard analog.
Digital (DTV) RF Antenna Connection
• Connect an RF antenna to the Digital Antenna In
terminal.
The digital tuner in this DTV receives digital signals
from an antenna. Digital signals from a Set-top Box
(STB) are received through the Component In jacks.
This DTV can receive ANY resolution being broad-
cast. However, ALL resolutions are converted to
480i for display.
RF
Antenna
DTV Back
DTV Back
VCR Back
DTV Back
VCR Back
(Continued on next page.)
OR OR