Sanitaire 6000 - Manual (Page 2)

2
To reduce the risk of fire, electric shock, or injury:
• Your machine is equipped with a safety switch lock and
power switch triggers designed for your safety. Do not
attempt to bypass or defeat the safety switch lock. Never
use any device to lock the power switch triggers in the
“ON” position.
• Do not leave the floor machine when plugged in. Turn off
the switch and unplug the electrical cord when not in use
and before servicing or changing the brushes or pads.
• Do not allow the machine to be used as a toy. Close
attention is necessary when used near children. Do not
leave the machine connected to an electrical outlet
unattended.
• Use only as described in this manual. Use only
manufacturer’s recommended attachments.
• Do not use with a damaged cord or plug. If the machine is
not working as it should, has been dropped, damaged, or
left outdoors return it to a service center before using.
• Use care to keep the electrical supply cord from contacting
the rotating brush or drive block.
• Do not pull, close a door on, or pull the cord around sharp
edges or corners. Keep the cord away from heated surfaces.
• Connect to properly grounded (3-wire) outlet only refer to
Grounding Instructions, Pg 3.
• Do not use extensions cords or outlets with inadequate
current carrying capacity.
• Turn off all controls before unplugging.
• Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
• Do not handle the plug or floor machine with wet hands.
• Wind the cord no tighter than is necessary to retain it during
storage. Refer to Cord Storage, Page 7.
• Use extra care when working near stairs.
• Do not use in conjunction with flammable or combustible
liquids such as gasoline, or use in areas where explosive
vapor or dust may be present.
• Store your floor machine indoors in a cool, dry area.
• Keep your work area well lighted.
• Warning - To avoid electrical shock, use indoors only.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
SAVE THESE INSTRUCTIONS
GENERAL INFORMATION
Use the cleaner to pick up dirt and dust particles. Avoid picking
up hard or sharp objects that could damage the vacuum
cleaner.
Service Information
The instructions in this booklet serve as a guide to routine
maintenance. For additional service information, telephone
our toll free number for the nearest Eureka Authorized
Warranty Station. You should know the model, type and
serial number or date code when you call:
USA: 1-800-800-8975 Mexico: 5670-6169
Canada: 1-800-282-2886
If you prefer, you can write to The Eureka Company, Service
Division, 807 North Main St., Bloomington, Illinois 61701, USA.
In Canada, write to The Eureka Company, 866 Langs Drive,
Cambridge, Ontario N3H 2N7. Refer to The Eureka Warranty
for complete service information.
DO NOT OIL the motor or the brush drive. The
motor and brush drive are permanently sealed
and lubricated.