Sunbeam Food Slicer - Manual (Page 5)

5
Using your Sunbeam SaladExpress.
Before using your SaladExpress
• Wash each of the parts of the SaladExpress
thoroughly before use, as described in the
Care and Cleaning section of this instruction
booklet. Use warm water and a mild
detergent on all parts except the cover,
which should be cleaned with a damp cloth.
Important: Do not immerse the cover of the
SaladExpress in water.
Important: Ensure that you handle the grating
and slicing discs with care as the blades are
extremely sharp.
• Dry each part thoroughly before use.
• Before you assemble the SaladExpress, ensure
that the power cord is unplugged.
Assembling the SaladExpress
1. Hold the cover of the SaladExpress upside
down, or place it upside down on a dry
surface.
2. Fit either the grating or slicing disc over the
drive shaft on the cover. Turn the twist cap in
a clockwise motion to fasten the disc securely
to the cover of the SaladExpress. See figure 1.
3. Place the processing/serving bowl on a clean,
dry, surface and set the basket inside it. See
figure 2.
4. Turn the cover of the SaladExpress right side
up and place it onto the processing/serving
bowl. The raised notches on the outside edge
of the grating and slicing discs fit inside the
lip of the basket.
5. Fasten both of the safety latches over the
edge of the bowl. Latches will snap into
place. See figure 3.
Important: As a safety feature, the SaladExpress
will not operate unless the latches are correctly
locked in place.
6. Make sure the function control switch, located
on the back of the cover handle is in the ‘Off’
position. Plug the power cord into a 230-240V
AC power outlet and turn the power on. The
SaladExpress is now ready for use.
(Figure 1)
Twist cap
Drive shaft
(Figure 2)
(Figure 3)
Latch unlocked
Latch locked