Sony DVP-CX860 - Manual (Page 14)

14
Getting Started
2+1 Channel Surround Hookups
This connection is for listening to the sound through the
left and right speakers of the TV, or speakers connected to
a receiver and the subwoofer. You can enjoy rich bass
frequencies by connecting a subwoofer. Refer to the
instructions supplied with the component to be
connected.
Set “SUBWOOFER” in “SPEAKER SETUP” to “YES” in
the setup display (page 76). Then set “FRONT SPEAKER
SIZE” to “TV” when you use the TV’s speakers, or to
“LARGE,” “MIDDLE” or “SMALL” when you use the
speakers connected to the receiver.
z You can enjoy surround sounds even if you connect front
speakers only
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (VES: Virtual Enhanced Surround). For details, see
page 51.
Required cords
Audio connecting cord (not supplied) (1)
S video cord (supplied) (1)
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
Monaural audio cord (not supplied) (1)
One for a subwoofer
White (L)
Red (R)
White (L)
Red (R)
CD
L
R
S VIDEO
VIDEO
AUDIO
INPUT
L
R
AUDIO OUT DIGITAL OUT AUDIO IN
OPTICAL COAXIAL
PCM/DTS/MPEG/
DOLBY DIGITAL
Y C B C R
MEGA
CONTROL
S VIDEO
OUTPUT
VIDEO
OUTPUT
COMPONENT
VIDEO OUT
T LINE-1 (RGB) - TV
WOOFER OUT
L
R
L
R
i LINE-2
INPUT
Note
You cannot enjoy the picture with S video signal if your TV does
not conform to the S video signal. When your TV does not have
an S VIDEO input, connect the component via the VIDEO INPUT
connector using the video connecting cord (not supplied) instead
of the S video cord. For details, see page 9.
Refer to the instructions supplied with your TV.
CD/DVD player
To AUDIO
OUT (R, L)
To audio input
: Signal flow
To mains
To S VIDEO
OUTPUT
To S VIDEO
input
To audio input
TV Subwoofer
(Active type)
Receiver (Amplifier)
To
WOOFER OUT
or