4. setting of the dip switches – Star Micronics DP8340 User Manual
Page 32
– 28 –
7-4.
Setting of the DIP Switches
Factory settings : all ON
Switch
Function
ON
OFF
1
Character Table (See below)
2
3
Control cord CR
Disable
Enable
4 (*1)
Printing Direction (Red printing)
Bi.
Uni.
5 (*2)
Ink Ribbon
2-color
monochrome
6
7
International Character Set (See below)
8
(*1) DIP Swich 4 should be set to OFF when you use 2-part sprocket
paper having the seam on the right since the ribbon snags at the
seam if shifted.
The DIP Switch 4 Should be otherwise set to ON.
(*2) DIP Swich 5 should be set to ON when you use a 2-color ribbon
for 2-color printing.
It should be set to OFF when a monochrome ribbon is used.
Character Table
SW NO.
USA & Europe
IBM#1
IBM#2
JAPAN
1
ON
OFF
ON
OFF
2
ON
ON
OFF
OFF
International Character Set
SW NO.
USA
France Germany England Denmark Sweden
Itary
Spain
6
ON
OFF
ON
OFF
ON
OFF
ON
OFF
7
ON
ON
OFF
OFF
ON
ON
OFF
OFF
8
ON
ON
ON
ON
OFF
OFF
OFF
OFF
Note: When DIP Switches 1 and 2 are set to OFF, the printer always
selects the Japan international character set regardless of the status
of DIP Switches 6, 7 and 8.
When DIP Swiches 1 and 2 are otherwise set, the printer selects
the character set determined by DIP Switches 6, 7 and 8.
Each international character set is selectable through software
regardless of the selection by DIP Switches.
Figure 7-4. DIP Switch Setting