Schneider Electric 107FB4/10 - Manual (Page 12)

TV Menu
Picture TV
Sound PC
Features
Install
Mode π
Your TV can be used as a computer monitor.
You must first of all connect the computer and adjust the resolution (see p. 6).
Choosing PC mode
Press the PC key on the remote control to switch the TV to PC mode. Press the TV key to return to
TV mode. If there is no PC signal for more than five seconds, the TV automatically goes into standby
mode.
Using the PC menus
PC mode
Picture π Brightness
Audio selection Contrast
Features Horizontal Pos
Reset to Factory Vertical Pos
Mode Colour Temp
Features
Phase
Clock
Format
Auto adjust
Using in PC monitor mode
Press the MENU key to access the specific settings of the
PC monitor mode. Use the cursor keys to adjust them (the
settings are automatically saved).
Picture
• Brightness/Contrast : to adjust the brightness and
contrast.
• Horizontal/Vertical Position : to adjust the horizontal
and vertical placing of the image.
• Colour Temperature : to adjust the colours (cool,
normal or warm).
Audio selection
To choose the sound reproduced on the TV
(
PC or TV ).
Features
• Phase/Clock : eliminates the horizontal ( Phase ) and
vertical ( Clock ) interfering lines.
• Format : to choose between large screen ( Full screen )
or the original ( Native ) format of the PC screens.
• Auto adjust : position is set automatically.
Reset to Factory
To return to the factory settings
Mode
To come back to TV mode.
8
Features menu
Timer
This menu lets you use the TV set as an alarm.
& Press the MENU key.
é With the cursor, select Features , then Timer .
“ Sleep : to select an automatic standby period.
‘ Time : enter the current time.
Note: the time is updated automatically each time
the TV set is switched on via the teletext
information on programme 1. If the programme
does not have teletext, the update will not take
place.
( Start Time : enter the start time.
§ Stop Time : enter the standby time.
è Program No .: enter the number of the
programme for the wake-up alarm.
! Activate : the settings include:
• Once for a single alarm;
• Daily for each day,
• Off to cancel.
ç Press the B key on the remote control to put
the TV set in standby. It will automatically come
on at the time programmed. If you leave the TV
set on, it will just change programmes at the
time entered (and will go to standby mode at
the Stop Time).
2328.1 gb 07-03-2005 09:26 Pagina 8